SKB 3I1711XLX Molded Case For Shure Slx & Ulx Microphone Systems

Based on the proven 3I Series design, this case was designed to hold Shure SLX and ULX wireless systems. Interior foam can hold the receiver, quarter and half wave antennae, handheld mic, bodypack, lavalier mic, 9V and AA batteries, mic clip and power supply. Other wireless systems from other manufacturers MAY fit in this case, however, the foam is cut specifically for the Shure SLS and ULX wireless systems.

3I Series injection molded waterproof cases are constructed of ultra high-strength polypropylene copolymer resin and feature a gasketed, waterproof and airtight, submersible design (IP67) that is resistant to corrosion and impact damage. Its continuous molded-in hinge, patent pending "trigger release" latch system, comfortable, snap-down rubber over-molded cushion grip handle, secure stacking, and automatic ambient pressure equalization valve (MIL-STD-648C) all contribute to its military grade design.

Key Prouduct Features:

• Ultra high-strength polypropylene copolymer resin
• UV, solvent, corrosion and fungus resistant (MIL-STD-810F)
• Complete gasket seal makes these cases absolutely watertight (MIL-STD-C-4150J)
• Automatic ambient pressure equalization value (MIL-STD-648C & IP67)
• Resistant to corrosion and impact damage
• Continuous molded-in hinge
• Patent pending "trigger release" latch system
• Rubber over-molded cushion grip handle
• Locking loop to accept a customer supplied lock
• Interior Length 17.00 in 43.18 cm
• Interior Width 11.50 in 29.21 cm
• Interior Depth 6.00 in 15.24 cm
• Lid Depth 1.75 in 4.45 cm
• Base Depth 4.25 in 10.80 cm